A good base

Arntjen Solar uses only the best mounting systems. Individually tailored to your project. We use systems including

Montavent
montavent installation systems associate innovation with security and  ease with longevity. Short profile beams with blind rivets that form three legged footprints avoid conceptional mechanical stress due to temperature change. Blind rivets are durably leak-proof, which protects against roof damage and guarantees a reliable high quality installation.

montavent TRAPEZ for framed solar modules
The Swiss PV Assembly System Complies with DIN 1055-4 for Wind Suction. An obligatory binding wind suction test is carried out for each installation, to ensure that the system in the sheeting withstands wind suction force. The sealing rivets are tested by TÜV Rheinland for their ability to withstand tensile forces in various types of sheeting.

Small Parts.
Take Advantage of Easy Handling and Low Costs.
All of the montavent system components are less than 45 cm in length. They are delivered in handy cardboard boxes, facilitating ease of handling, storage, transport and installation saving you time and money.

montavent LAMINAT for frameless solar modules
The Swiss PV Assembly System Complies with DIN 1055-4 for Wind Suction.
An obligatory binding wind suction test is carried out for each installation, to ensure that the system in the sheeting withstands wind suction force. The sealing rivets are tested by TÜV Rheinland for their ability to withstand tensile forces in various types of sheeting.

Short Profiles.
Take Advantage of Easy Handling and Low Costs. Our system components have a maximum size of about 1 m, which facilitates storage, transport and installation on the roof can be done by one person. This reduces your costs and time.

Rapid Placing.
Place Your PV Laminate Without Drilling the Profile. All montavent components are delivered form ready and predrilled, which allows easy and custom-fit assembly of your solar field on the roof. The fixation is directly installed on the bearing profile, which is part of the laminate clamp at the same time. Specifically conceived rubber bearings with clamped caps professionally anchor the lamination with defined forces for a lifetime.

No Damages on the Roof.
Avoid Dangerous Shearing Forces Thanks to Short Profiles. No sheet cracks in the roof, no water damage because of leaky bodies and no fatigue breaks to deck screws: The retaining foot has been specifically conceived to decouple dangerous shearing forces between the installation system and the trapezoidal roof. The “full floating” profiles therefore do not cause any stress damage - in contrary to long profiles where temperature changes can unleash destructive forces.